GH50R

Key Features

Digital Reverb

Digital Reverb

Studio quality digital reverb with Pull focus

XLR-DI OUT

XLR-DI OUT

The XLR-DI out allows you to connect your amplifier to a PA system or recording interface, without the need for micing. It is fully balanced and features a level switch for -30dB (PA/Desk level) or +4dB (Line level) for driving powered cabinets directly. The XLR-DI out also features a ground lift switch is also provided for lowest noise performance. Unlike most other XLR-DI out, the Laney fitted XLR-DI out is post the output section of the amp.

Pull Shift on Mid EQ

Pull Shift on Mid EQ

Pulling on each of the EQ control knobs will shift the response of each control as follows: Bass: Deep - This extends the low-end frequency response, resulting in a fuller, heavier sound for lower notes. Mid: Shift - This lowers the frequency range of the mid control to give a tighter sound. Treble: Shift - This broadens the Treble control frequency response, to give a rounder sound to higher notes, especially when used with thin sounding pickups.


  • Switchable cabinet emulation


  • FS2-MINI included


  • FX loop series/switchable level


  • Premium Hand selected ECC83 & EL34 tubes


  • Slip cover supplied


  • 2 Channels


  • 50 watts RMS


  • The ability to blend the amount of preamp and output distortion

Specification

  • Extension speaker socket: 1 x 16 Ohm, 1 x 8 Ohm, 2 x 16 Ohms, 1 x 4 Ohms & 2 x 8 Ohms
  • Master Tone & Master Output
  • Item dimensions: 235mm x 675mm x 285mm (HWD)
  • Carton dimensions: 331mm x 824mm x 349mm (HWD)
  • Item weight: 19.00kg

Manuals

Tina
Maynard
Soeur
"Punk rock never sounded so good."
Jamie
Lenman
Solo
"Its been a Laney on stage with me for over 20 years. What else do I possibly need behind me!"
Andy
Ghosh
Turbowolf
Serg
Demitrijevic
Earth, Wind & Fire

Social